How to Install a Hand Held Shower Head
Installing a hand held shower head can be a simple and rewarding DIY project that can significantly enhance your bathroom experience. Whether you’re looking to upgrade your existing shower system or install a new one, following these step-by-step instructions will guide you through the process with ease.
Materials Needed:
Before you begin, gather the following materials:
– Hand held shower head
– Shower arm extension (if needed)
– Shower arm
– Shower bracket
– Teflon tape
– Adjustable wrench
– Screwdriver
Step 1: Turn Off the Water Supply
Ensure the water supply to your shower is turned off. This can typically be done by turning the valves located on the cold and hot water supply lines under your sink. It’s important to do this to prevent any water from escaping during the installation process.
Step 2: Remove the Existing Shower Head
Loosen the nuts that secure the existing shower head to the shower arm using an adjustable wrench. Once the nuts are loose, carefully remove the shower head from the arm.
Step 3: Check the Shower Arm Length
Inspect the length of your shower arm. If the current arm is too short to accommodate the hand held shower head, you may need to purchase a shower arm extension. Attach the extension to the existing shower arm using the provided nuts and washers.
Step 4: Install the Shower Bracket
Attach the shower bracket to the wall, ensuring it is securely fastened. The bracket will support the hand held shower head and can be adjusted to fit different heights.
Step 5: Attach the Shower Arm
If you’re using a new shower arm, slide it over the bracket and secure it in place using the provided nuts and washers. Tighten the nuts with an adjustable wrench until the arm is securely fastened.
Step 6: Install the Hand Held Shower Head
Attach the hand held shower head to the shower arm using the provided nuts and washers. Make sure the head is securely fastened to the arm, but not too tight, as this may damage the threads.
Step 7: Apply Teflon Tape
Wrap a length of Teflon tape around the threads of the shower arm and the hand held shower head. This will help create a watertight seal and prevent leaks.
Step 8: Reconnect the Water Supply
Turn the water supply valves back on and check for any leaks. If there are no leaks, you can proceed to enjoy your new hand held shower head.
Conclusion:
Installing a hand held shower head is a straightforward process that can be completed in a few simple steps. By following these instructions and taking the necessary precautions, you can upgrade your bathroom experience and enjoy the convenience of a hand held shower head.
